Skip to main content
OpenEye Knowledge Base

OE-C3212D8-S Hardware Manual - Features and Contents

OE-C3212D8-S Hardware Manual - Features and Contents

Important Safeguards

Warranty

Camera Dimensions

Connections

Features

Box Contents

User Manual

Important Safeguards 

View Important Safeguards before installing the camera.

Warranty 

View the Product Warranty for the camera.

Camera Dimensions

C3212D8-S Line Drawing Measurements.png

Connections

C3212D8-S Connections Line Drawing.png C3212D8-S Reset SD Card Microphone Callouts.png

1 RJ45 For network and PoE connections
2 Power (12vDC) Power Connection (12vDC power input should be plugged when not in use)
3 Audio I/O Ground
Audio In
Audio Out
4 Alarm I/O Ground
Alarm In
Alarm Out -
Alarm Out +
5 Reset Button

To restore the camera to factory defaults:

  1. Disconnect power for 30 seconds.
  2. Reconnect power and wait 30 seconds.
  3. Press and hold the reset button for 20 seconds. 
6 microSD Card Slot

Supports up to 512GB microSD card for Edge storage.

Do not add or remove the microSD card when the camera is powered on.

7 Built-in microphone
Power Connection

For an adequate power connection, use a 12vDC adaptor. Alternatively, you can power the camera by PoE if a Power Sourcing Equipment (PSE) switch is available. Ensure that the camera’s power cable is correctly and firmly connected.

NOTE: OpenEye recommends against using more than one power source at a time. Do not use a PoE power source when providing the camera with 12vDC power.

If using Power over Ethernet (PoE), make sure Power Sourcing Equipment (PSE) is in use in the network.

Features
  • Person, Vehicle, Line Crossing Detection Analytics
  • Corridor Mode
  • NDAA Compliant
  • 2.8~12mm VF, AF, Zoom Lens
  • 8MP | up to 20FPS
  • Audio I/O
  • Alarm I/O
  • Adaptive IR | up to 131' range
  • True WDR @ 8MP
  • Built-in microphone
  • IK10 Impact Protection Rating
  • IP67 Ingress Protection Rating
  • Optional Paintable Dome Cover (Free Upon Request)
Box Contents

OpenEye C3212D8-S cameras come with self-tapping screws and plastic anchors, mounting template, a torx tool, and a waterproof cable connector. Identify the following components to make sure everything has been properly included with your new recorder. If any of the following items are missing, contact the dealer to arrange a replacement.

C3212D8-S Line Drawing.png

OE-C3212D8-S Dome Camera

Screws and Anchors.png

Self-Tapping Screws and Plastic Anchors x3

C33212D8-S mounting template.png

Mounting Template

 

waterproof cable connector.png

 

Waterproof Cable Connector

 

torx tool.png

Torx Tool

 
  • Was this article helpful?