Standard Motion
Configure a Standard Motion Area
- From the Analytics tab, check Motion Detected.
- Select Standard from the Analytics Mode dropdown.
- Click Setup under the Configuration column.
- Click Add Area, then click and drag the capture square to create the area.
NOTE: Left click, release, and move to draw a custom polygonal shape one line at a time. Draw and click the last line to the starting point to complete the Area.
NOTE: Motion Areas can be subtracted to disable motion detection for specific areas of the video stream and motion grids can be drawn over each other.
NOTE: Resize the area of interest by dragging the bottom right-hand corner of the camera confirmation pane.
- Continue modifying Motion Areas as desired using the tools below the camera frame.
Motion and Motion Region Options
Motion Sensitivity – Reduce or increase the sensitivity of motion detection.
Noise Sensitivity – Reduce or increase noise sensitivity detected on a camera.
Pre Motion Recording – Time when recording starts from a motion event.
Image Offset – Offset when an image is captured from a motion event.
Record on event detection – Remove the check to disable events from being recorded on the event stream.
Reset Defaults – Resets motion sensitivity and noise sensitivity back to default values.
Select – Allows motion detection grids to be moved.
Select All – Draws a full motion detection grid over the image.
Add Area – Draw individual motion detection grids.
Remove Area – Allows removal of motion detection grid areas within a grid.
Clear All – Removes all motion detection area grids.
- Click Save.
Delete a Standard Motion Area
- Click to select the desired Motion Area.
- Click Remove Area to delete the selected area.